JOHN COOK HOVERCRAFT SUPPORT PAGE
|
|
| 1 | So you want to make a Hovercraft |
|
||||||||||||||||
| 2 | This is what you will need | |||||||||||||||||
| 3 | Use a knife and safety ruler to score the duct | |||||||||||||||||
| 4 | Use a strip of tape to hold the duct in shape | |||||||||||||||||
| 5 |
Use tape to hold the motor
in place Push on the propeller |
|||||||||||||||||
| 6 | Rest the super capacitors in place. Trim back the wires as shown | |||||||||||||||||
| 7 | Remove the tab from the chip box lid | |||||||||||||||||
| 8 | Place the tower centrally and draw around the base | |||||||||||||||||
| 9 | Mark and then cut out the duct opening | |||||||||||||||||
| 10 | Place the duct into position and attach with three strips of tape | |||||||||||||||||
| 11 | Connect the wires and attach the super capacitors | |||||||||||||||||
| 12 | Attach the magnet with a short length of cotton | |||||||||||||||||
| 13 | Charge the capacitors | |||||||||||||||||
| 14 | Close the reed switch and away it goes! |
|
Electronic support files
from John Cook in Real PCB File Format
|
||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
